Search in Category

Lifting Pin Plus Recess System
Search term required.

Filter Your Search

Please note: All items are not yet available for use with our Filtered search.
If an item is not available via the filters, try searching for the part number or description using the search box at the top of the page.

SHOP BY CATEGORY

Lifting Pin Plus Recess System

 Need Technical Support?Email: tech@alpsupply.com

The ALP Lifting Pin Plus Recess Member is constructed of a durable polyurethane material which improves tear, heat, and chemical resistance compared to the standard rubber material. ALP Supply® Plus Stud Plate, Wing Nut, Holding Rod, and Tapped Plates are designed so that they are interchangeable for all sizes of recess members.


One size fits all 2T, 4T and 8T recess members.

The ALP Stud Plate is used to mount the Plus Recess Members to the form using the following steps:

Install the stud plate into the recess member.
Insert the lift pin into the recess member.
Insert the stud plate through a hole in the form.
The 3/8” wing nut is then used to tighten the recess member to the outside of the form.


One size fits all 2T, 4T and 8T recess members.

The ALP Holding Rods and Tapped Plate are used to mount the Plus Recess Members to the form. Standard Finish: Plated

Installation Instructions:
Insert the tapped plate into the recess member.
Insert the lifting pin to the recess member.
Align the recess member to a pre-drilled hole in the form. The holding rod is then threaded into the recess using the fixed end coil nut until the thread bottoms out .
The movable wing nut is then tightened down until it is snug against the side of the form.


The ALP Lifting Pin Plus Magnetic Holding Plate is a magnetic option that easily attaches to the side of steel forms.

Viewing Page 1 of 1 (10 results)
Direct Ship
UOM : EA
1-29$54.50
30-49$51.78
50+$49.05
Qty:
In Stock
UOM : EA
$8.79
Qty:
LPPSP

STUD PLATE, LIFTING PIN PLUS, 3/8" X 4"

Item # LPPSP
"FOR ALP PLUS RECESS MEMBERS, PLATED (100/CTN) (USE WITH *LPWN38* COIL WING NUT)"

In Stock
UOM : EA
$3.24
Qty:
LPPTP

THREADED PLATE, LIFTING PIN PLUS

Item # LPPTP
"3/8"" COIL FOR ALP PLUS RECESS, PLATED (300/CTN) (USE WITH *QL202* HOLDING ROD)"

In Stock
UOM : EA
$2.00
Qty:
LPWN38

WINGNUT, 3/8" COIL

Item # LPWN38
FOR USE WITH LPPSP STUD PLATE (300/CTN)

In Stock
UOM : EA
$2.05
Qty:
Direct Ship
UOM : EA
1-29$82.50
30-49$78.38
50+$74.25
Qty:
In Stock
UOM : EA
$12.30
Qty:
In Stock
UOM : EA
$18.41
Qty:
Direct Ship
UOM : EA
1-29$122.50
30-49$116.38
50+$110.25
Qty:
© 2019 ALP Supply. All Rights Reserved.